Sometimes you have no other options, but when you do it is always better to do it right. Fixing it later is what we in the biz call, 'Fixing it in the mix'. Or, rather, it is much better to remove the source of the noise than to try and filter it out later. I am not a fan of removing the noise after the recording process. If you still have problems then get a different mic. Try using it on a different computer, in a different building. Leave it to dry for a couple of minutes, and continue to use your headset static-free. Step 4: Repeat the process using several cotton swabs until the tip comes out completely clean. Once you've identified what is causing the EMI/RFI then you can do something about it.Īnd there is always the possibility that the mic is bad. &0183 &32 Step 3: Gently insert the tip of the cotton swab in the headphone jack and move it back and forth to clean it thoroughly. Try a longer USB cable so you can move it around more. Try moving the mic around the room and see if it gets more or less noise when in different positions. Move the mic and see if the noise goes away. The fans and hard drives in your PC/laptop could be vibrating the table which is coupling into the mic. You can figure out how to reduce background noise on mics by understanding what type of microphone you’re looking for. While you may not be able to get rid of ambient noise completely, you can cut back on interference. I'd like to add here that Matt is talking about mechanical vibrations. If your microphone is picking up unwanted sounds, there are steps you can take to minimize background noises and static. Make sure your gain isn’t turn up too high and see if that helps.

For XLR microphone, if you are you using a preamplifier or an audio interface, some preamps and audio interface can produce an unhealthy signal that can cause a buzzing / humming background noise.

If you're using a laptop, try running off of battery and the charger and see which one is better.Īs Jenkins said, maybe the mic is picking up the hum through the desk. Check Your Preamp And Audio Interface/Change another USB port. Try using a USB hub that has it's own power supply.

Remove background static microphone